If you have some fine desoldering braid you can use that to wick up some of the solder, however, some will most likely be left behind under the pins.Playing outside was pretty much a no go as sunlight would make the image washed out.
Nintendo saw it fit to include a contrast dial to help, but it didnt help a lot. If you want better contrast for your old DMG-01 Game Boy the best way is to install a bivert mod. So, how do you bivert a Game Boy Game Boy Bivert Mod: Biverting a Game Boys display involves soldering a bivert chip to the motherboard of the Game Boy. Why Bivert a Game Boy The main reason to bivert a DMG Game Boy is for additional contrast when using a backlight mod. Some people just prefer the inverted image the chip provides, and I have to admit it does look good in a few games and defiantly puts a unique spin on Tetris. Some games, like Links Awakening, look a little odd inverted, especially without the use of polarizing lensfilm. With the pixels flipped, what was once on is now turn off, light is dark etc. You get a much better contrast this way and it makes a big difference on-screen visibility. I have already installed a backlight mod but have yet to install the bivert chip so I thought I would walk you through it with me. Make sure any batteries and games are removed and lay the Game Boy down face down. Bivert Dmg Driver To GetRemove the battery compartment door and inside you will notice two screws as well as the four screws outside on the Game Boy, these special screws are called tri-point screws and you will require a tri-point screwdriver to get them out. Nintendo uses these security screws in a lot of their products and they are similar to a Philips screw head but have three points rather than four. Grab your tri-wing or tri-point screwdriver and take out all six of them. The cable may be a little stiff so be careful not to pull on it too hard. Step 2. Polarizing Lens Orientation If you have a back-light mod installed (like me), you are going to want to change the positioning of your polarizing Lens installed under the glass of your screen. To do this we will need to remove all the Philips head screws holding the front board and screen to the shell. Next, we flip over the board and will need to remove the two tiny Philips head screws holding the LCDs ribbon cable in place and carefully lift the screen and change the orientation of the polarizing film to 90 degrees. Please note that the screen does NOT fully lift up and is still attached via a ribbon cable Be careful and only pry it up slowly Ive already got mine installed in the correct orientation but thought I would show you in case you need to do this yourself. This is also a good opportunity to remove your buttons and silicone pads and give them a gentle clean if needed. Step 3. Lifting the Pins to facilitate Bivert Chip Now, on to the back half of the Game Boy. As you can probably tell from the Bivert chip we will need to solder two pins to the chip. Counting from right to left we will need to lift pins 6 7 so the bivert chip can slide underneath. Heat up your soldering iron and apply a little heat carefully to the pins and gently use your tweezers or a craft knife to get under the pins and gently lift them up.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |